机械过冷的制冷系统在汽车空调中的应用

由于很多汽车空调采用斜盘式压缩机，有利于采用机械过冷的制冷系统，来增加汽车空调的制冷量、提高制冷效率。本文的主要目的是通过对系统工质的流量分配、空调制冷量和性能系数(COP)与中间压力之间的变化关系的研究，来研究机械过冷在汽车空调中应用的可行性。     

工业锅炉定期排污装置运行管理

介绍了定排装置安装与改造过程中的注意事项,定排装置出现故障的处理方法和操作规程。     

聚酯装置熔体过滤器的国产化改造

熔体过滤器为聚酯装置关键设备,其国产化问题一直未能解决。该文通过对天津分公司200kt/a聚酯装置熔体过滤器改造方案的介绍,探讨了其国产化条件,分析了国产熔体过滤器的结构特点,并与进口过滤器进行了对比,提出了一些看法。     

空气压缩机无油润滑在山脚树矿的应用

山脚树矿有5台1966年上海生产的4L—20/8空气压缩机,运行很不经济,利用聚四氟乙烯合成材料制成活塞环,全部实现无油润滑运转,取得了良好的经济效益。     

"摩圣"技术在空气压缩机上的应用

介绍了4L-20/8型空气压缩机采用"摩圣"技术后的运行情况。"摩圣"技术在设备正常运行条件下能成功修复摩擦副的磨损,使之恢复原设计的尺寸和要求,因而提高了生产效率,取得了显著的经济效益。     

小型别墅中央空调的新风设计

提出了小型别墅中央空调新风处理的方法，就某别墅采用本方法作中央空调新风设计，并以其计算数据为依据，验证了本方法的可行性。     

垂直定向液晶光阀及光电特性的研究

系统地讨论了排列相畸变模式液晶光阀结构，原理和制作，结合实际测试对其等效电路和电学匹配进行了分析，详细讨论了它的光电特性及相互关系，实测的液晶垂直排列方式工作的液晶光阀性能指标为，分辨率大于５０ｌｐ／ｍｍ，白光输入灵敏度为６．７７μＷ／ｃｍ＾２，响应时间为２００ｍｓ／３００ｍｓ，白光输出对比度为２００：１。     

码分多址（CDMA）技术和公用空中接口综述

本文主要讨论数字移动通信中扩频码分多址技术，阐明了ＣＤＭＡ体制的优越之外，分析了ＣＤＭＡ的关键技术，全面介绍了ＣＤＭＡ系统设计的基本原则和ＩＳ－９５－Ａ空中接口标准的含义。     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

用发生炉煤气进行快速热风烤窑的应用

用发生炉煤气进行快速热风烤窑的应用王善波，王志军（山东荣成市玻搪工程有限公司２６４３０９）ＰｒｏｄｕｃｅｒＧａｓＵｓｅｄｆｏｒＦａｓｔＨｅａｔｉｎｇｕｐＴａｎｋＦｕｒｎａｃｅ￥ＷａｎｇＳｈａｎｂｏ；ＷａｎｇＺｈｉｊｕｎ（ＳｈａｎｄｏｎｇＲｏｎｇｃｈｅ...